Thursday, September 13, 2012

Check and repair the steering mechanism in the Zhiguli

Whether on the working surfaces of the roller and worm wear, scuffing, dents or scratches. Worn and damaged parts replaced, the gap between the sleeve and the shaft of a bipod. If it is larger than this, then replace the bushings, the ease of rotation of the shaft roller bearings bipod and a worm. Last turn freely without binding on the surface of rings and balls should not be visible wear or damage heartbeat support cervical steering shaft relative to the average diameter of the splined shaft opening tip. To do this, the lower end of the shaft wear special mandrel, which is mounted on the lens. While cranking the mandrel on the prism base beating neck should not exceed 3 mm. If the shaft is bent, then straighten it by hand press, the axial gap between the head of the adjusting screw and keyway shaft 11 bipod. Clearance shall not exceed 0.05 mm. If it is, replace the adjustment plate one more on the plate thickness.

0 comments:

Post a Comment